工业测试线组

SureGrip™ accessories are designed to improve steadiness in slippery hands. Rubber overmolded surfaces and finger-hugging curves give the user a comfortable, reliable grip on the accessory so they can focus on making an accurate measurement.

DMM test leads (red, black) with safety shrouded, standard diameter banana plugs Right angle connector on both ends Reinforced strain relief 1.5 meter silicone-insulated wire resists heat & cold CAT IV 600 V, CAT III 1000 V, 10 A rating. UL listed One year warranty

Handy all-in-one kit that includes :

AC220 SureGrip™ Alligator Clip Set TP1 Slim-Reach™ Test Probes (flat bladed) TL224 SureGrip™ Silicone Test Lead Set (straight to right) One year warranty

Electricians know that when you are measuring electrical installations there often appears to be a voltage, even if you know the wires are non energized. This is called stray or ghost voltages and is caused by the capacity between wires. Because of the very high impedance input of the meter, this stray voltage has nowhere to go which will lead to an incorrect reading on the meter.

The solution is to make sure there is a lower impedance across the input terminals of the meter. However, this is not as easy as it seems since it is vital that the safety of the electrician is not compromised.

The Fluke TL225 is the solution:

It makes sure the meter has a low input impedance that eliminates stray voltages. On energized wires, the meter will indicate the real voltage. On non-energized circuits the meter will read close to zero (even if there are stray voltages). It can be used with all modern meters with standard input spacing. Rated CAT III 1000 V, CAT IV 600 V One year warranty

Kit includes:

SV225 Stray Voltage Eliminator TL224 SureGrip™ Silicone Test Lead Set (right to straight) TP220 SureGrip™ Test Probe Set C75 Accessory Case

An accessory kit especially designed for working in high energy enviroments. The SureGrip™ Test Probe has only 4 mm of exposed metal at the tip. Test probes with less exposed metal help reduce the risk of inadvertant shorts between each other and other metal surfaces that could result in an arc flash explosion. Probe extenders fit between modular test leads and test probes, increasing the distance between you and a live circuit by 20.5 cm (8").

The kit includes:

TP238 SureGrip™ Insulated Test Probe Set TP280 SureGrip™ Test Probe Extender TL224 SureGrip™ Silicone Right Angle/Straight Test Lead Set

TP238 and TL224 conform to safety standard IEC 1010-2-031, maximum 1000V CAT III, 600V CAT IV, Pollution Degree 2, 10A

Probe extenders conform to safety standard IEC 1010-2-031, maximum 1000V CAT III, Pollution Degree 2, 10A